Kramer-electronics SL-10 Manuel d'utilisateur

KRAMER ELECT RONIC S LTD. USER MANUAL MODEL: SL-10 Master Room Controller P/N: 2900-000581 Rev 4

SL-10 - Connecting the SL-10 7 4 Connecting the SL-10 Always switch off the power to each device before connecting it to your SL-10. After connec

8 SL-10 - Connecting the SL-10 8. Connect the K-NET port to any RC device with K-NET. Figure 2: Connecting the SL-10 Master Room Controller 4.1 U

SL-10 - Connecting the SL-10 9 Figure 3: RS-232 Connection 4.3 Connecting the RS-485 Interface To connect an AV device to the SL-10 using the RS-4

10 SL-10 - Connecting the SL-10 After connecting the Ethernet port, you have to install and configure it. For detailed instructions on how to instal

SL-10 - Operating the SL-10 11 5 Operating the SL-10 You can operate your SL-10 using:  An RC family remote controller: To operate your device

12 SL-10 - Technical Specifications 6 Technical Specifications INPUTS: 2 RS-232, RS-485, 2 GPI/O and K-NET on terminal block connectors; Ethernet o

For the latest information on our products and a list of Kramer distributors, visit our Web site where updates to this user manual may b

SL-10 – Contents i Contents 1 Introduction 1 2 Getting Started 2 2.1 Achieving the Best Performance 2 2.2 Safety Instructions 3 2.3 Recycl

SL-10 - Introduction 1 1 Introduction Welcome to Kramer Electronics! Since 1981, Kramer Electronics has been providing a world of unique, creative,

2 SL-10 - Getting Started 2 Getting Started We recommend that you:  Unpack the equipment carefully and save the original box and packaging materi

SL-10 - Getting Started 3 2.2 Safety Instructions Caution: There are no operator serviceable parts inside the unit Warning: Use only the Kramer El

4 SL-10 - Overview 3 Overview The SL-10 is a highly versatile controller that acts as an all-in-one control processor for control of A/V equipment—

SL-10 - Overview 5 3.1 Defining the SL-10 Master Room Controller This section defines the SL-10. Figure 1: SL-10 Master Room Controller # Feature

6 SL-10 - Overview # Feature Function 8 K-NET Connector PIN GND is for the Ground connection; PIN B (-) and PIN A (+) are for RS-485, and PIN +12V