Kramer-electronics VP-31 Manuel d'utilisateur télécharger pdf (Page 13)







Figure 5: Typical VS-2000 System Setup

9.4.2

DIP Switches

The VP-61RS selects one of 6 VGA/Super-VGA/XGA standard signals. As said before there are two options

for operating the switcher, both are available without removing the switcher cover.

 It can be operated by touching one of the front panel switches.

 It can be operated by a remote PC via the RS-232 connectors on its rear panel.

The DIP switch (see Table 4) on the rear panel is used when the switcher is operated via the RS-232 connector

or when it is interconnected with other switchers. These switches allow proper configuration of the control

signals received/transmitted through the RS-232 control port. The VP-61RS allows master/slave

configurations so that the switchers may operate independently, or in conjunction with each other.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Pas de commentaire

Kramer-electronics VP-31 Manuel d'utilisateur Page 13