Kramer-electronics RC-13TC Manuel d'utilisateur télécharger pdf (Page 7)

RC-13TC - Defining the RC-13TC Video Transport Controller 5

Figure 2: RC-13TC Video Transport Controller Rear Panel

# Feature Function

4 KNET TERM Termination Switch Use to set the K-NET bus termination (see

Section

5.2.2)

5 KNET 4-pin Removable Terminal

Blocks (1 and 2)

Connect to a master room controller or to another

auxiliary device.

Connect GND to GND, B to B, A to A, +12V to

+12V (see Section

5.2)

6 RESET (DEFAULT) Factory

Default Reset Button

Press and hold during power-up to erase all

custom programming.

Note: The current LCD text and all button actions

are erased

7 Ring Tongue Terminal Grounding

Screw

Connect to grounding wire (see Section 6)

8 RS-232 3-pin Removable

Terminal Block

For controlling a display, switcher, AV source or

other AV equipment

9 IR Infrared 2-pin Removable

Terminal Blocks (1 and 2)

Connect to IR emitters (see Figure 3).

Connect OUT 1 or OUT 2 to IR+ (anode), GND to

GND (cathode)

10 PROGRAM (USB) Connector Connect to a computer to program the unit ID,

LCD text and button actions using K-Config

Configuration software

11 Power Supply 2-pin Removable

Terminal Block

Connect to power supply (see Section 5.1.2).

Connect GND to GND, +12V to +12V

12 FW UPGRADE Switch For the use of Kramer service personnel only

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

Kramer-electronics RC-13TC Manuel d'utilisateur Page 7