Kramer-electronics RC-43T Manuel d'utilisateur télécharger pdf (Page 14)

RC-43T - Connecting the RC-43T

5.1 K-NET Wiring

The K-NET connector on the RC-43T must be connected to a room controller via a

four wire cable as shown in Figure 7 and Figure 8.

Figure 7: RC-43T K-Net Wiring US Version

Figure 8: RC-43T K-Net Wiring EU Version

Note: The RC-43T is always device ID 2 on the K-NET bus and cannot be

changed.

To connect the RC-43T to a room controller:

 Connect pin 1 on the K-NET connector to pin 1 on the room controller K-NET

connector (+12V to +12V)

 Connect pin 2 on the K-NET connector to pin 2 on the room controller K-NET

connector (A to A)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Kramer-electronics RC-43T Manuel d'utilisateur Page 14