Kramer-electronics RC-53DLC Manuel d'utilisateur télécharger pdf (Page 11)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Defining the RC-53DLC

4.3 Grounding the RC-53DLC

The grounding screw is used to earth the chassis of the unit to the building ground

preventing static electricity from impacting the performance of the unit.

Figure 5 and Table 5 define the grounding screw components.

Figure 5: Grounding Connection

Components

Table 5: Grounding Component

Descriptions

Component Description

M3X6 screw

1/8" Toothed Lock Washer

M3 Ring Tongue Terminal

To ground the RC-53DLC:

1. Connect the Ring Tongue terminal to the building grounding point wire (it is

recommended to use a green-yellow AWG#18 (0.82mm

) wire, crimped with

a proper hand-tool).

2. Insert the M3x6 screw through the toothed lock washers and the tongue

terminal in the order shown above.

3. Insert the M3x6 screw (with the two toothed lock washers and ring tongue

terminal) into the grounding screw hole and tighten the screw.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Kramer-electronics RC-53DLC Manuel d'utilisateur Page 11