Kramer-electronics PL-50 Manuel d'utilisateur télécharger pdf (Page 32)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Operating Your PL-50 Power Controller – Monitor

To set the Standby mode

1. Press one or more OUT buttons to select the channels for which you want to

measure the standby or active modes.

The selected buttons illuminate.

, do the following:

2. Set the connected units to the Standby mode

3. Press the PRESET LEVEL STANDBY button.

The selected orange OUT buttons, and their related STANDBY orange LEDs

blink.

4. Press each of the selected orange blinking buttons to initialize the

measurement.

The STANDBY orange LED blinks until measurement is complete.

To reset the active and standby values on all channels, press the RESET

button on the rear panel while turning the power ON.

You can measure the Active and Standby values as well as reset individual

channels via the embedded Web pages (see section

6.3.2

1 The unit should be powered up and running under typical conditions when the measurements are made

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Pas de commentaire

Kramer-electronics PL-50 Manuel d'utilisateur Page 32