Kramer-electronics RC-43T Manuel d'utilisateur télécharger pdf (Page 9)

RC-43T - Defining the RC-43T Remote Controller

Figure 2: RC-43T Remote Controller Rear View US Version

Feature

Description

Mounting Holes

Attach the RC-43T to the wall mounting box

with the screws provided (see Section 6.2)

Front Panel

Cosmetic panel that covers the PC Board and

houses the removable buttons

PC Board Frame

Mounting panel that houses the PC Board

PC Board

SW7 K-NET

Termination Switch

Use to set the K-NET bus termination (see

Section 5.2)

KNET 4-pin Captive-

screw Terminal Block

Connect to a master room controller or to

another auxiliary device (see Section 5.1).

Note: The RC-43T is always device ID 2 on

the K-NET bus. This cannot be changed

PC Board Frame

Alignment Tongue

Align this tongue with the cutout in the front

panel when mounting the PC Board frame to

the front panel

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Kramer-electronics RC-43T Manuel d'utilisateur Page 9