Kramer-electronics RC-80 Manuel d'utilisateur télécharger pdf (Page 11)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Your RC-80, RC-160 and RC-160L Remote Control Machines

Table 2: Front Panel RC-80/RC-160/RC-160L Remote Control Features

Function # Feature

RC-80 RC-160 RC-160L

1 IR Receiver The red LED is illuminated when receiving signals from the Infra-red remote

control transmitter

2 LOCK Button Disengages the front panel switches

Select the output to which the input is to be routed 3 OUT / OUTPUT

SELECTOR

Buttons

From 1 to 8 From 1 to 16 From 1 to 16

Select the input to switch to the output 4 IN / INPUT

SELECTOR

Buttons

From 1 to 8 From 1 to 16 From 1 to 16

5 VIDEO Button When button illuminates, actions relate to video

. Press to toggle

6 AUDIO Button When button illuminates, actions relate to audio

. Press to toggle

7 TAKE Button When in the Confirm mode, press to implement a single action. Press to toggle

between Confirm and At Once mode

Displays the selected input switched to the output (marked above/below each input) 8 STATUS Display

7-segment LED LCD LCD

Table 3: Rear Panel RC-80/RC-160/RC-160L Remote Control Features

Function # Feature

RC-80 RC-160 RC-160L

9 LCD Contrast Trimmer Not applicable Turn to adjust LCD contrast

10 RS-485 Terminal Block

Port

Pins B (-) and A (+) are for RS-485; Pin G (Ground) may be connected to

the shield of the cable if desired

11 RS-232 IN 9-pin D-sub Port

Connects to the PC or to another Remote Control

12 RS-232 OUT 9-pin D-sub

Port

Connects to a Kramer switcher or another Remote Control

13 SETUP DIP-switches See section 6.4

14 Flash Upgrade Button Push in for “Program” to upgrade to the latest Kramer firmware (see

section 8), or release for “Normal” (the factory default)

15 ETHERNET Connector Connects to the PC through computer networking (see section 6.2)

16 Reset Button ETHERNET factory reset button. Press to reset to factory default

definitions

IP number  192.168.139

Mask – 255.255.255.0

Gateway – 192.168.11

17 12V DC +12V DC connector for powering the unit

1 The RC-80 and RC-160L have large buttons, and the RC-160 has small buttons

2 Press both VIDEO and AUDIO buttons (both buttons illuminate) for the audio channels to follow the video channels (AFV,

audio-follow-video mode)

3 Insert a screwdriver into the hole and carefully rotate it, to trim the level

4 First disconnect the power adapter and then connect it again while pressing the Reset button. The unit will power up and

load its memory with the factory default definitions

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

Kramer-electronics RC-80 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Panneau de contrôle Kramer-electronics RC-80