Kramer-electronics VP-790 Manuel d'utilisateur télécharger pdf (Page 10)

8 VP-790 Blending Images - Setting Blend Width

• Line 1 is the left hand edge of the right hand projection

• Line 2 is the right hand edge of the left projection blend region

• Line 3 is the left hand edge of the right projection’s blend region

• Line 4 is the right hand edge of the left hand projection

Referring to

Figure 6 above, adjust line 3 to meet line 1 and adjust line 2 to meet

line 4. This adjusts the blend width of each projector so that the shadowed

alignment area is equal to the optical overlap.

Figure 7 shows a darker vertical strip on the right hand side where the blend width

has been adjusted past the overlap (blend width is too wide) and on the left hand

side a lighter vertical strip showing a blend width that is too narrow.

Figure 7: Blend Width Incorrectly Adjusted

Figure 8 shows the view when the blend widths on both Scalers are adjusted

correctly.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Kramer-electronics VP-790 Manuel d'utilisateur Page 10