Kramer-electronics VP-790 Manuel d'utilisateur télécharger pdf (Page 7)

VP-790 Blending Images – Setting the Basic System 5

2. Select the horizontal grey bars test pattern in one of the two following ways:

 Exit the OSD menu and use the up/down arrow buttons on the front

panel to cycle through the available patterns

 In the top OSD menu select Input, and then Test Pattern Setup and Test

Pattern. Select Grey H Bars

2.1.3 8BSetting the Position in the Matrix

Define the position of each VP-790 unit in the matrix:

1. From the Setup menu, set the Operation Mode to Multiunit.

Figure 4: Multiunit Screen

2. Set a 2 x 1 matrix system:

 Set Units Wide to 2

 Set Units High to 1

3. Define the position of each VP-790 unit separately:

 Select the H-Position on the VP-790 unit connected to the left hand

projector to 0

 Select the H-Position on the VP-790 unit connected to the right hand

projector to 1

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Pas de commentaire

Kramer-electronics VP-790 Manuel d'utilisateur Page 7