Kramer-electronics VM-3VN Manuel d'utilisateur télécharger pdf (Page 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Connecting Your Distribution Amplifier

5.3 Connecting Your VM-3VN Video DA

To connect

the VM-3VN, as illustrated in the example in Figure 6, do the

following:

1. Connect the composite video source to the INPUT BNC connector.

2. Terminate the input by ensuring that the TERM switch is pressed to the IN

position.

3. Connect the OUT BNC connectors (from 1 to 3) to up to three composite

video acceptors

4. Connect the 12V DC power adapter to the power socket and connect the

adapter to the mains electricity (not illustrated in Figure 6).

5. If required, adjust output equalization (EQ) and signal level (LEVEL) by

turning the appropriate trimmer with a small screwdriver.

Figure 6: Connecting the VM-3VN Video Distributor

1 Switch OFF the power on each device before connecting it to your VM-3VN. After connecting your VM-3VN, switch on its

power and then switch on the power on each device

2 You do not have to connect all the outputs

1 2 ... 7 8 9 10 11 12 13 14 15

Pas de commentaire

Kramer-electronics VM-3VN Manuel d'utilisateur Page 12