Kramer-electronics VM-1045 Manuel d'utilisateur télécharger pdf (Page 9)

Connecting a VM-1045 Video Component Distributor

6 Connecting a VM-1045 Video Component Distributor

To connect the VM-1045 as illustrated in the example in Figure 3, do the

following

1. Connect a component video source (for example, an RGBS camera) to

the INPUT connectors.

2. Connect the LOOP BNC connectors (from channel A to channel D) to

the INPUT BNC connectors

on the next VM-1045 machine.

3. Connect the OUT 1 connectors of each channel

to the acceptor (for

example, RGBS display 1).

4. Connect the OUT 5 connectors of each channel

to the acceptor (for

example, RGBS display 5).

5. Connect the power cord

(not shown in this illustration).

6. If required, on the machine underside, for each channel, adjust the:

 EQ.

 LEVEL

1 Switch OFF the power on each device before connecting it to your VM-1045. After connecting your VM-1045, switch on

its power and then switch on the power on each device. Switching on the VM-1045, recalls the previous setup from the non-

volatile memory

2 On each channel

3 You do not need to connect all the outputs

4 We recommend that you use only the power cord that is supplied with this machine

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Kramer-electronics VM-1045 Manuel d'utilisateur Page 9