Kramer Electronics FC-5 Manuel d'utilisateur télécharger pdf (Page 19)

16 FC-5 - Using the FC-5

6.3 Transmitting Commands via the Relays

You can use your FC-5 to transmit commands via the relays:

Figure 15: Transmitting Commands via the Relays

A PC or Remote Controller is connected to the COM1 port. Relay 1 is connected

to the blinds, and relay 2 is connected to the lighting system. On each 3-pole

terminal block connector, connect either: C to NO, or C to NC

Figure 16: Relay Pinout

C Common

NO Normally Open (that is, the electricity is switched ON)

NC Normally Closed (that is, the electricity is switched OFF)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Kramer Electronics FC-5 Manuel d'utilisateur Page 19